Hello,

I'm using Holding Registers Points to drive registers in a slave PLC.

I would like to force these registers but I realise that I can only force to "0" (zéro) but not to "1" ... Is there anybody that faced this situation before ?
When I use Coil Status Points, it works well ...

I could use Coil Status points to do this but I'm afraid of how Mango will handle requests, I've about 50 points in the field and would be sure that mango will not trigger them individualy , I mean sending 50 "Read Coil" requests instead of sending few "Read Holding Regiters" requests.

I've posted another question relative to Logging modbus requests, an answer of this previous question would of course answer to this point ... :shock:

Thanks,

Nicolas