Hi there I am hoping someone can assist here
I am trying to add 2 MODBUS data sources but am getting a “No response from slave error” for each device. (however when I test in a Modbus test programme I am having no issue and am able to send commands and receive responses with no delay etc) I have double checked the settings on the devices match the Mango serial properties for each data source
1)The First device is a Level Meter connected on virtual com port via RS485 Modbus RTU (connected on a COM2)
It is not detected on the Modbus Node Scan and generates a ” error
- The second Device is a Flow meter connected on a virtual COM port via RS485 Modbus on (COM1)
It is not detected on the Modbus Node Scan and generates a “no response from Slave 2” error
Are there settings elsewhere I need to configure in Mango?