I'm doing project using mango, raspberry pi and PLC .My mango software is running on raspberry pi 3 model B computer. PLC is connected to raspberry using USB serial cable. I access raspberry pi using Putty software which is running on my laptop.(Rsapberry pi is connected to my laptop through router). when i run mango on raspberry pi it is working properly. but when I scan node using Mango interface (I accessed mango interface by using ip and port ) there is no any node detected. (but when i run mango on my laptop it is working properly and Mango can detect nodes).
there is three ports are automatically detected by mango when it run on raspberry pi. they are /dev/ttyUSB0 , /dev/ttyAMA0 and /dev/ttyS0.
can anyone help me ?