I'm using Mango Automation V3.3.2
so My project have 2 mango, the first run in raspberry pi (IP address:10.62.41.189) and another one run in PC (IP adress:10.62.41.121).
It is every well to send data point from raspberry pi by HTTP Sender (Publish) and the PC using HTTP Receiver (Data Source) to get the data point into it. The picture below are some setting of mango run in raspberry pi.
and this picture below are some setting of mango run in PC.
I'm got the data by check in the watch list as show below
for now i can settable data name SW1 only 1 way raspberry pi (sender) -> to PC (receiver) as show in below the left hand side is PC and the right hand side is raspberry pi
I need help i want to settable data name SW1 force back from PC to raspberry pi, but for now i can't do. it have no response. i will show in below
Q1: Set point URL setting correct or not?
Q2: Set point name setting correct or not?
PS. apologize for very long post.