Attached is a water flow point that I would like to add an alarm value too. I know I could set an high/low value, but the flow changes constantly. See the photo of a history snapshot. Should I go with a high/low value or maybe have an accumulated value over time to trigger an alarm? If so, I guess I need to build a point add the sum of an hour or something like that?

@craigweb

Well it turns out, the device required the "Use multiple write commands only" to be turned on. Thanks for the help.

@thomaseinasto
Thanks Thomas. I think I understand some of this. When I use the write tool I put 740 to get a 74° set point so once I get the right multiplier + additive combo it should work?

@thomaseinasto

I really don't see anything but I'm limited as to what to look for. I'm using chrome.
The MC6 Test stat is the device.

Re: {Modbus TCP write or settable](/topic/4560/modbus-tcp-write-or-settable)

Register 64 (all R/W) points, while using the tool you can see in yellow hi light it will write, but the actual point will reads the value but when I use the "set" command to change the value nothing happens.

I can write to a point from the Modbus IP properties "write data" tool but I can't get it to work within the points.
Attached are photos

)

Can I get the text needed to filter the ma-point-list so only the "temp" point show in the dropdown? Thanks