• S
    Shawn_H

    Hi there,
    Am interested in possibly integrating Mango into our current network and thought I would start out with the trial version just to poke around and see if it fits the need. Downloaded, ensured JDK 8 was installed etc. when running ma-start, local host comes up on 8080, loads to 40% then error message : Request Error/unable to load/status. Pretty sure the environmental paths are set correctly, when looking at the cmd.exe , it is coming up error, cannot access RandomAccessFile.

    Any assistance would be greatly appreciated.
    Thanks,
    Shawn

    posted in Mango Automation Installation read more
  • S
    Shawn_H

    Hi Joel,

    Thank you very much for taking the time to respond! I was kind of thinking this might be the case and BACnet is an element of possibility; it may just need to be done in phases or we go S4. Either way, this is good intel to bring back to the table to support moving forward with looking at Mango more seriously!

    Thanks Again,

    Shawn

    posted in Mango Automation general Discussion read more
  • S
    Shawn_H

    Hi there, have heard a lot of great things about Mango and may be in a position where I may be able to put Mango to use on a rather large site consisting of Delta Controls And Johnson Controls. The Delta end I am not worried about, but has anyone had any experience integrating the JCI gear with Mango? Currently they are nit integrated onto (1) network and the JCI gear is communicating via its N2 protocol ( BACnet is possible) There has been discussion about incorporating S4 on site to put it all under (1) umbrella but I need to weigh all options before making any decisions. Any assistance or input would be greatly appreciated!

    Thanks,

    Shawn

    posted in Mango Automation general Discussion read more