I have finally got the PLC side of the facility working and now have just about finished implementing the Mango interface to the PLCs to show operational details. I have about 450 points, Most of them are binary status bits (status lights) that I want to reflect on the mango screen. I can pull the status information from the PLC and can see the data being read via the data source "lego" block hover. My problem that I am having is that only about 150 of my approximate 450 points show up on the drop down list when I try to select one of the points from the XID list for an ma-indicator or numeric data display. Any idea where the rest of the list is at or why it is not showing up.
I have broken down the two PLCs into about 4 data sources each. All my data sources point to only two devices, the two plcs that inferface via Modbus IP I.For instance, I have a data source setup with the one PLC IP address and then the points are for analog data. Another does the same but pulls binary registers and bits/coils. Another pulls registers that buffer the VFD status word. I have searched for a solution but as yet have not found an anwer. I am using the MangoES box with 3.x Mango Firmware, etc. I can also see the data point data in question (missing and not missing on the XID drop down list) in my watch lists.